Chairside Complete Denture Try-in Workflow

In the checkout flow for your patient's denture, you can fabricate your denture straight-to-finish or start with a Try-in

  • Note: Denture try-ins are done with a Monolithic Try-In. This is an off-white 3D-printed denture to mimic the final prosthesis without wasting costly denture teeth. (see below for a picture)

Dandy_r1_SEA_1426 (1).jpg

If you choose Try-in, you will see instructions on how to proceed once the try-in arrives. We will also email you the instructions for the next steps.

You will then proceed with the rest of your order and wait for the try-in to arrive. Dandy will now deliver the try-in to your practice. 

Try-in Appointment

We recommend bringing up the order page in Chairside while the patient is in the chair.

Look for the “Review Try-in” banner on the order page to guide you through the next steps (see below).

image5.png

Review the try-in with your patient for fit, aesthetics, and phonetics.

Providing Feedback

You will now provide your feedback to Dandy in a guided, step-by-step process. 

DenturesTryin.png

Review & Submit

Finally, you will review your feedback, make any necessary edits, and rescan the patient if any structural changes are needed.

Note: You will be prompted to re-scan the patient if any structural changes are needed to the denture. This will occur if you provide feedback within the Retention and/or fit, VDO, or Bite sections of the feedback walkthrough.

Was this article helpful?
4 out of 4 found this helpful
Live Support Hours
Monday - Friday: 8 am - 9pm ET Saturday: 9 am - 4 pm ET
Chat With Us
By clicking here and logging into your account on the Dandy Portal.
Call Us
At (267) 310-3332 or tap here to call us on your mobile phone.