Follow these steps to complete the implant workflow within the software:
Initial Case Setup
Start a New Case: Initialise the process within the system.
Add Patient Details: Enter the patient’s name and click OK.
Select Teeth: On the dental model (located on the left-hand side of the screen), select the applicable tooth numbers one at a time.
Define Restoration: Once a tooth is selected, go to the centre of the screen and choose Crown.
Implant Configuration: * From the dropdown menu titled ‘Implant-based?’, select either Stock or Custom Abutment.
A new box will appear; click this to enter the specific implant information (Brand, Connection, and Platform Size).
Click OK.
Material Selection: Choose the preferred crown material and shade from the dropdown list.
Repeat: Perform these steps for every restoration site in the case.
Scanning Procedure
Initiate Scan: Once all implants are configured, select New Scan in the top right-hand corner.
Follow Sequence: Adhere to the scanning flow displayed at the top centre of the page.
Capture Emergence Profile: For arches where implants will be placed, use the pre-op scan to capture the emergence profile.
Bite Registration: Ensure you take the bite scans prior to seating the scanbodies.
Place Scanbodies: After completing the pre-op scans for the treatment arches, place your scanbodies.
Scanbody Page: When you navigate to the scanbody scan page (top centre), the scan will initially appear in black and white.
Trimming and Finalising
Mark the Site: On the left-hand side, select the Mark Tooth icon (represented by a pushpin and a plus sign).
Highlight Areas: Click and hold your cursor over the restoration sites; they will turn green.
Trim Data: Select the Scissor icon on the left. This trims out the previously captured data to prime the scan for the new scanbody information.
Capture Scanbodies: Scan only the specific restoration sites where the scanbodies are present.
Finalise: When scanning is complete, click Finish at the top centre of the screen to finalise the data.
Submission
Send Order: Click Send Order.
Laboratory Form: The Dandy lab slip will appear on the screen. Fill out the prescription details thoroughly.
Submit: Click Send when finished.