Dandy’s precise digital design and 3D printing process result in a highly accurate splint. You save time when there are no adjustments. Our 3D Printed night guard combines strength to fight bruxism and softening thermodynamic technology for unmatched comfort.
Seating the Splint
The 3D Printed Night Guard contains softening thermodynamic properties. Heat splint under hot water for 20-30 seconds before placing it on your patient’s teeth. Doing this adds flexibility, allowing for a comfortable fit with minimal to no adjustments.
Cleaning & Care
Daily Cleaning
Dandy recommends cleaning your appliance daily before and after every use. Immediately after removal, use warm water (not to exceed 45°C/113°F) and soap to remove remaining saliva and debris from the device.
Cleaning Agents
For periodic debris removal and maintenance, you can use any mild over-the-counter cleaning agents
designed for oral devices. If needed, use a soft bristle brush to clean the inside of your appliance for debris removal. Some validated cleaning agents include Dawn dish soap, Polident, Efferdent, 3% peroxide solution, 15% bleach solution, and mouthwash.
Cautions
- DO NOT SOAK your appliance in any liquid for more than 1 hour.
- DO NOT use abrasive cleaning agents (i.e. toothpaste) as it can shorten the life of your appliance.
- Dispose of the cleaning solution after every use. Rinse the appliance well prior to use.
- DO NOT SOAK the appliance in water hotter than 45°C/113°F due to the risk of warping the device.
Click here for a downloadable PDF version of this article.
