This article includes information on sterilization of your equipment.
Mirror Tip Sterilization
Dandy provides five mirror tips with every onboarding kit. The below article outlines the best practices for sterilizing mirror tips and scanner components.
Sterilization Standards for Mirror Tips
Mirror tips last for 150 autoclave cycles.
Mirror tips should be pouched during an autoclave cycle.
Use the autoclave setting for plastic or regular.
No other instruments should be autoclaved at the same time, as this will cause premature failure of the mirror tip.
Nothing should be bagged or on the same shelf as the mirror tips -\alternate materials can change the temperature more rapidly and damage tips.
Mirror tips should be sterilized after each patient use.
Ultrasonic cleaner should NOT be used with mirror tips.
Autoclave Settings for Mirror Tip Sterilization
273 degrees for 4 minutes in the autoclave with a 10-minute dry cycle.
250 degrees for 45 minutes in the autoclave with a 10-minute dry cycle.
Statim: 270 degrees for 5 minutes.
Mirror Tip Approved Cleaning Methods
Autoclaving per the above instructions.
Diluted dish soap and a nylon bristle toothbrush. These steps can be followed before autoclaving to ensure proper sanitization and a spot free mirror.
The Mirror Tip Should Never be Cleaned With:
- Biosurf (This can etch the mirror and glass and delaminate the plastics)
- Ethylene Oxide Gas
- Hydrogen Peroxide
- Lysol Wipes
- PDI Sani-Cloths
- Sani Cloth
- Sklar Wipes
- Ultrasonic (pre-autoclave)
- Volo Wipes
Mirror Inside of Mirror Tip
The autoclaving process will not remove any smudges or marks on the mirror. This could cause issues with the scanning and calibration. To clean obstructions on the mirror, use a Q tip brand Qtip and isopropyl alcohol to spot-clean the mirror. The cotton applicators often found in dental offices and should not be used as the alcohol will dissolve the glue securing the cotton tip and can transfer more debris onto the mirror. Alternatively, the entire mirror tip can be cleaned using distilled anti-bacterial soap and a nylon bristle toothbrush.
Scanner Wand & Base Approved Cleaning Methods
- Optim Wipes
- Hydrogen Peroxide
The protective tip should not be autoclaved. This will damage the protective tip. The protective tip should only be used to protect the lens in the neck of the scanner during transport or longer term storage.
The scanner lens is located in the neck of the scanner wand and can be accessed when the mirror tip is removed. The scanner lens should only be cleaned if there are visible smudges or debris present. Any smudges or marks on the scanner lens will create issues with calibration and scanning.
- A microfiber eyeglass cloth can be used if there are visible smudges or debris on the lens. The lens should not be regularly cleaned if there are no visible obstructions. Minimal pressure should be applied when cleaning the lens.
- If you need to sterilize the lens (this should only be done if there is a visible obstruction on the lens), use 70% or higher isopropyl alcohol and a Q tip brand Q tip. The standard cotton swab found in most dental offices should not be used; the glue holding the cotton in place will be dissolved by the alcohol and can transfer onto the lens. Minimal pressure should be applied when cleaning the lens.
- The mirror tip provides protection to the lens, meaning sterilization does not need to be done between patients.
• • •
Want to download and print the above PDF for your office?
Download the attached PDF at the bottom of this article!